Spectra Logic 10000 User Manual download pdf (Page 65)

Chapter 5. Operating the Library

Barcode Chksum The library supports Code 39 bar code labels, with or without a

checksum digit. Configure the library for the type of bar codes you are using:

• If you are using bar codes with a checksum character, touch the + symbol to enable

Barcode Chksum.

• If you are using bar codes with no checksum digit, ensure that Barcode Chksum is

disabled.

• Touch Save Parms > Yes to save changes and rescan the library’s inventory.

Autoread Barcodes This option forces the library to automatically resynchronize the

media inventory by reading media bar codes after every bulk load or unload media

operation. If this option is disabled, the library only resynchronizes (by reading bar

code information) when prompted by the host software.

• Touch the + symbol to enable Autoread Barcodes, or the - symbol to disable

Autoread Barcodes.

• Touch Save Parms > Yes to save changes and rescan the library’s inventory.

Barcodes Screen

If a bar code scanner is installed, the BC button is visible on the move tapes screen.

• If a bar code scanner is installed but not enabled, the BC button is available, but

tapes are not automatically scanned.

• If a bar code scanner is not installed, the ER button is shown in place of the BC

button. The ER button allows access to the first ECC screen (see ECC Screens on

page 83).

From the main screen, select Move Tapes > BC to display the bar code screen (shown in

Figure 5-3).

Figure 5-3 The Barcodes screen.

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 135 136

No comments

Spectra Logic 10000 User Manual Page 65