Spectra Logic 10000 User Manual download pdf (Page 59)

Chapter 5. Operating the Library

Moving Tapes

To move a single tape, use the Move Tapes screen. To access this screen, from the main

screen, touch Main > Move Tapes.

To move a tape:

1. Place a tape into the door slot. The door indicator on the Move Tapes screen

darkens, indicating the tape is loaded into the door.

2. Touch the slot or drive to which you want to move the tape. A message appears

in the upper left corner of the screen indicating which source location is

selected.

Note: If a bar code scanner is installed, and the tape has been read by

the bar code scanner, the bar code label will also appear in the

upper left corner of the screen.

3. Touch the screen button corresponding to the destination of the tape. The

library moves the tape.

• If you select an occupied destination, the library displays the message Move

Destination is Full. Touch OK to clear the message. Touch a valid destination

button to re-initiate the move.

• To cancel a move after a source has been selected, press the source button a

second time.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 135 136

No comments

Spectra Logic 10000 User Manual Page 59